Immersion furnace FTE 1

 

Specific functions

  • Complete cycle is done under gas protection
  • Cycle without chock to the pieces
  • Semi-automatic cycle to move the basket
  • Monitored excess temperature safety  (+20 °C)
  • Flame detector
  • Monitoring of flames with H2 pilot
  • Automatic ignition system for protective gas, type «Piezo»
  • Backup for 256 recipes
  • Introduction of values for temperatures, passing time etc. on HMI
  • Display of measurements and faults with date and time as well as the state of alarms
  • Visualising of the temperature curve history
  • Automatic ON/OFF mode for the heating and the gases, with standby program

 

Heating
 
  • Heating elements fitted onto ceramic tubes
  • 3 heating zones per chamber with temperture adjustment via thyristor
  • Temperature tolerance in the heating zones ± 5°C
  • Thermocouple type S.
  • Maximum temperature 850 °C
  • Power control for the heating zones

 

Water immersion tank
 
  • Cooling via lost water or connected to the client’s network
  • Water temperature 20 to 35°C
  • Water level monitoring
  • Water flow monitoring
  • Water circulating pump with filter
  • Maximum admissible pressure on the cooler, 1.5 bars
  • 3 cooling modes:
            - Without immersion in water tank
            - With immersion in water tank
            - Immersion in tank, with goods 
              movi vertically
 
 
 
 

Various options are available upon request !

  
  • Backup for 2000 recipes
  • Bar code for recipes
  • Bar code for the operator
  • Remote maintenance
  • 1 USB port on the operator panel for screen print
  • Print-out for alarms (if compatible)
  • Print-out for temperature curves (if compatible)
  • 1 temperature sensor for the calibration of the heating channels
  • Plate heat exchanger for the cooling system
  • Ammonia cracker (NH3)
  • Baskets without cover
  • Baskets with cover
 

  03 FTE 1